These seat covers were originally manufactured in leather. 4 factory colors of leather as original or we can substitute vinyl with wide vertical pleats with smooth seat caps. All installation listingsare attached. Seat shell material and sewn front seat back hard shell back covers.

This is our universal front seat foam for 1949 to 1952 Convertible models. This has been tested in our shop and fill out the seat covers perfectly. High density bottom layer of foam and a softer 1/2 foam top layer. Ships in 2 large oversize boxes.

This is our contour shaped universal rear seat foam for the 1949 to 52 Convertibles. Bottom layer is thick high density foam with a softer 1/2" layer of top foam. We have tried and tested this foam and use nothing else on our seat cover installations. Ships in 2 large oversize boxes.

New waterproof cardboards with edge metal support bands with nails attached. Two tone colors of vinyl on the panels with upper lighter center panels with horizontal stitching above the door panel stainless and dark vinyl on the lower panel sections. Sewn rear armrest covers. Vinyl covered windlace for door openings. Vinyl covered kick panels, vinyl to recover armrests.

These are a pair of replacement front plastic bases with stainless trim strips and top pads. Top rubber pads are covered in vinyl. Complete ready to install. 

Vinyl covered 1/2" sponge rod in the correct lenghts. Two front windlaces have kick panel channel slide in mounting cords and dash filler flaps. We can make this windlace set in many colors.

Black Textured board die cut to the correct shape for proper fit. Sold in pairs for left and right sides.  We can also vinyl cover these to your interior color.

Waterproof 1/8" thick boards that are die cut for the 2 door Convertible front doors. Window crank and door handle holes are push outs.

These are for the rear trim panels, mount above the rear armrests. Die cut waterproof boards with window crank and door handle push outs.

Galvanized U shaped door edge metal bands that surround the door board.  Nail included. This is a 2 door set. 

For all years. These fit between the door panel and the edge metal band, and just need crimping to secure in place. Sold in groups of 10 for $7.50 with Free Shipping.

New hand made sun visors starting with new boards with metal rods attached. Padded with a thin layer of cotton padding and covered with interior vinyl. Vinyl edge binding and finger tabs. We can do these in many vinyl colors as listed.

This is a Nylon Pin Point GM grain heat sealed convertible top. Includes side pads and plastic back window with brass zipper and front windshield edge windlace. Heavy weight vinyl cut from tested and true patterns. Available in many colors.

Black canvas cut and sewn to the proper shape and size for the convertible top storage area.  Ask about your desired color, we'll try to do it if we can.

Made to fit the 1949 to 1952 Chevrolet Convertibles. Interior vinyl cut and sewn to the proper configuration and shape, all edges use the same vinyl binding on all edges. Under stiffner support under snaps.

This is the tiny loop tight weaved carpet, cut and sewn as the originals were. All vinyl binding on the edges and over the tunnel,  vinyl heel pad. 1/8" latex foam and jute padding underside.

This is a cut and sewn carpet set in tight cut pile carpeting. Jute padded underside. Vinyl edge binding with matching vinyl heel pad. We can also us loop carpet material.

This is a four mat set, we manufacture in our shop Using close weave cut pile or loop carpet with nibbed rubber non slip back. All edges are vinyl bound. Many colors available.