Convertible all vinyl Seat covers, or we can add Hardtop cloth inserts. Preassembled front doors and rear trim panels, sewn armrest covers and top piston covers, windlace set, sunvisors, vinyl covered kick panels. Convertible top boot, Tuxedo carpet set and matching Tuxedo floor mats. 70 lbs*  You must send us your door upper rails or purchase ours, window felts and lock ferrules included.

Another Ciadella Interiors 1st, this is the only available exact reproduction 1959 Impala Convertible multi-colored square design insert vinyl in all colors using correct welts. Our Seat Covers are sewn using heavy weight original Seville grain vinyl in two colors with the vertical Chrome mylar strips heat sealed on the back rests. All installation listings attached. We can also make these covers using Hardtop cloth inserts if you would like. 20 lbs

This kit is high density layered foam in the size and shape to repad the front seat. This is the same foam we have used and tested when we install our seat covers in our shop.  20 lbs. O.S.

Sold per seat, cushion and backrest.

Rear bench seat seat high density foam with 1/2" foam top layer. This is what we use in our installation department and we do not have to add any other foam or batting. Minor trimming required.   20 lbs.

This vinyl is the only reproduced 1959 Impala Convertible insert vinyl, another Ciadella 1st, in all colors in the correct long square multi colors design. Sold per yard, 54" wide. 2 1/2 yards needed per car. 3 lbs per yard

Heavy weight non expanded Seville crush grain vinyl as used in 1959 -1964 Chevrolets. Manufactured in all of factory colors, 54" wide. Samples sent on request. 3 lbs per yard.

This is the 1957 Bel Air armrest assembly we reproduced in many colors. Complete with plastic base, vinyl covered rubber pads, ready to mount. Next picture is the 1962-64 Impala. Both look good on 1960 Impalas. Call please. 5 lbs pair.

 These are assembled front door and rear quarter trim panels for the 59' Convertible. Complete and ready to install your stainless trim. *You must send us your upper front & rear panel rails or purchase ours and we will install them FREE. New window felts and lock ferrules are included. Heavy weight vinyls in the correct factory colors and grain with upper vertical mylar strips, center Herringbone scallop and lower heat sealed design. New waterproof boards, galvanized edge metal bands with nails installed. Sewn rear armrest and top piston covers, windlace set, vinyl covered kick panels. No door panel stainless included. 35 lbs

This is the 1957 Bel Air armrest assembly we reproduced in many colors. Complete with plastic base, vinyl covered rubber pads, ready to mount. Next picture is the 1962-64 Impala. Both look good on 1959 Impalas. Call please. 5 lbs pair.

Precision die cut waterproof boards with punch outs for window handles or power window switches and holes for interior trim. These will now warp. Sold per pair. 10 lbs

Reproduced out of metal to duplicate the originals in every way. Size, contour and shape. 5 lbs.per pair.

1959 Impala Convertible rear upper trim rails are made out of heavy ABS and formed to the exact shape and size of the originals. Sold in pairs. 5 lbs.

Made especially for the 1959 Convertible rear trim panels. Add your upper rails or purchase our reproductions. Waterproof die cut boards with push outs for window cranks. Sold in pairs.

Door panel edge metal bands for the sides and bottom attaching rail. Made out of Galvanized metal to conform with the shape of the 1959 Convertible door boards. This set is for the two front doors. Installation nails included. 4 lbs

These are excellent replacements to replace broken or missing door panel edge metal installation nails. Easy to install by placing between the door board and the metal adge band in the location needed. And simply crimp. Sold in groups of 10 for for $7.50 with Free Shipping..

A pair of anti rattle lock knob ferrules. Round stainless top with inner felt. Easy to install, by bending the tabs on to the upper rails. Sold in pairs. 0.5 lb

This is a pair of Seat Belts in all the factory colors. Each is 68" in length with aircraft style chrome quick release buckels. This pair is for driver and passenger, rear seat belts also sold in pairs @ $50.00 for two.. 3 lbs pair.

Can be installed on all models. Complete with foamed under support. Covered with Seville grain vinyl as the originals were. Ready to glue onto the metal dash. In all the 1959 colors. This is not a hard plastic dash top cap. 20 lbs.

Reproduced Sunvisors using new boards and support rods. Padded and covered with the 1959 Seville crush grain vinyls in all colors. Completely edge bound. Sold as a pair. 5 lbs.

This is a Black canvas convertible top storage well. Cut and sewn to duplicate the original and give protection to the top when it is down. We can also make this in your interior color. 3 lbs.

This is a heavy 38 oz Pinpoint grain Convertible top with heat sealed side panels. Plastic back window with brass zipper. Top pads included. Tinted plastic rear window optional. Other colors available. 20 lbs

Made out of 1959 Seville grain vinyl in all the correct colors with matching edge binding. Support vinyl on the underside edges and foam padding on the convertible rail sides. Hidden snaps. Ready to install. 10 lbs

This is 4 pieces of 3/8" round sponge rod that is covered with the correct Seville grain interior vinyl. Staple in place for front kick panel area and rear of door opening. 3 lbs.

These are a pair of die cut heavy boards we professionally cover with interior vinyl. Sold in pairs for $59.95

This is solid color 80/20 loop carpet set ( Not the Tuxedo)  These are molded carpet sets in many colors that have jute underlay. Vinyl edge binding and plastic ribbed heel pad. Fit is good and will need trimming of excess carpet material. 

This item has additional shipping charges due to heavy weight or oversize dimensions.

 This is a molded carpet set for the 1959 Chevy's. Pressure and heat molded to the contour of the floor pan. Jute padded underside, vinyl heelpad. Covers front and rear areas, Some trimming required of excess carpet material. Should be gluded to floor for better fit.  

 This item has additional shipping charges due to heavy weight or oversize dimensions.

A 4 mat set for front & rear using Tuxedo carpet. Contour shaped for proper fit. Nibbed underside for non sliding. Matching vinyl edge binding. Plain loop carpet in many colors $85.00   10 lbs.